CFD analysis with AcuSolve

ViLaks · April 1, 2021, 08:05

Dear Rishi,

I am working on HW CFD Platform. Is it possible to do structured meshing? Whenever I mesh, I just get polyhedral meshing. I need to use hex elements, whcih shall reduce my element count drastically.

With Regards
Vignesh

ViLaks · April 7, 2021, 01:57

Quote:

Originally Posted by ViLaks

Dear Rishi,

I am working on HW CFD Platform. Is it possible to do structured meshing? Whenever I mesh, I just get polyhedral meshing. I need to use hex elements, whcih shall reduce my element count drastically.

With Regards
Vignesh

Hi Rishi,

My bad... I didnt explore all the options properly. I am now able to generate structured mesh.

Regards
Vignesh

ViLaks · June 14, 2021, 06:30

Hi,

I have run a simple pipe flow problem in steady state using Acusolve. I would like to plot pressure vs flow rate.

I would like to do that using Acuprobe. I would export pressure , velocities and area from acuprobe, calculate flow rate and do the plot in Excel.

However, I am confused on which values to export - Solution Ratio/Surface Statistics/Surface Output.

Also there are initial, final and all; minimum and maximum for both pressures and velocities and I am getting confused.

Can someone guide me on this.

Also, can I directly plot this in Acufieldview?

Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How do you do a fluent CFD analysis for a boat?	UHMStudent	FLUENT	2	July 24, 2011 12:45
CFD software capable of modal analysis?	Jim-gineer	Main CFD Forum	4	January 14, 2010 09:29
FDM vs FVM vs FEM in CFD analysis	ck5285	FLOW-3D	1	September 1, 2009 10:51
ASME CFD Symposium, Atlanta, 22-26 July 2001	Chris R. Kleijn	Main CFD Forum	0	August 1, 2000 10:07
CFD Analysis on Shock/Boundary Layer Interacton'-HELP	Mujahid S. Suhaeb	Main CFD Forum	8	December 1, 1999 17:14

April 1, 2021, 08:05		#41
ViLaks Member Vignesh Lakshmanan Join Date: Nov 2016 Posts: 79 Rep Power: 9	Dear Rishi, I am working on HW CFD Platform. Is it possible to do structured meshing? Whenever I mesh, I just get polyhedral meshing. I need to use hex elements, whcih shall reduce my element count drastically. With Regards Vignesh

June 14, 2021, 06:30		#43
ViLaks Member Vignesh Lakshmanan Join Date: Nov 2016 Posts: 79 Rep Power: 9	Hi, I have run a simple pipe flow problem in steady state using Acusolve. I would like to plot pressure vs flow rate. I would like to do that using Acuprobe. I would export pressure , velocities and area from acuprobe, calculate flow rate and do the plot in Excel. However, I am confused on which values to export - Solution Ratio/Surface Statistics/Surface Output. Also there are initial, final and all; minimum and maximum for both pressures and velocities and I am getting confused. Can someone guide me on this. Also, can I directly plot this in Acufieldview? Thanks