|
[Sponsors] |
Effect of crack on flow separation? Help please |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 27, 2005, 02:17 |
Effect of crack on flow separation? Help please
|
#1 |
Guest
Posts: n/a
|
Hi.... I need some advice for the leakage problem in my experimental model. I found a very tiny crack on the model that suck the air flow from outside (it's a suction type system). Since the crack is on the upper surface of a diffusing bend, will this increase or decrease the flow separation already existed in the region?
Thank you for any advice here. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wall function for flow separation region | rupa dutta | Main CFD Forum | 12 | April 28, 2009 16:43 |
Poor Convergence for Transient Subsonic Diffuser sims with flow separation | TWaung | CFX | 1 | April 16, 2009 08:25 |
Problems modeling subsonic engine air inlet with flow separation | TWaung | CFX | 2 | March 29, 2009 18:42 |
Can 'shock waves' occur in viscous fluid flows? | diaw | Main CFD Forum | 104 | February 16, 2006 05:44 |
Question on 3D potential flow | Adrin Gharakhani | Main CFD Forum | 13 | June 21, 1999 05:18 |