|
[Sponsors] |
July 29, 2014, 04:25 |
Negative Mass Flow Rate
|
#1 |
New Member
Join Date: Dec 2012
Posts: 24
Rep Power: 13 |
I have a question that I couldn't find a satisfactory answer anywhere so far,
I'm simulating the flow of water in an air conditioning distributor (so far it's one phase) so it's one inlet & four outlets. Why am I getting a negative mass flow rate at the outlets of my model? what does it depict? Because what I can see from the vector animation is that all the vectors are pointing to the same direction (as that of the inlet) which is in harmony with my simulation & hypothesis. I also played the simulation in CFD-Post, and the animation was quite confusing, as it kept going back & forth in two opposite directions. Can anyone please help me with that? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Split Mass Flow Rate in ANSYS CFX | ashtonJ | CFX | 2 | July 9, 2014 03:08 |
Mass flow rate at the outlet | tejasvikrishna | FLUENT | 2 | May 25, 2013 02:42 |
Mass Flow Rate is not converging | destgir448 | CFX | 5 | December 11, 2010 05:55 |
Mass Flow Rate | student87 | CFX | 4 | January 2, 2010 04:45 |
mass flow rate error | Masood | FLUENT | 0 | May 22, 2005 00:32 |