|
[Sponsors] |
February 11, 2009, 03:24 |
Fuse simulation
|
#1 |
Guest
Posts: n/a
|
Hello everybody!
I'm trying to simulate fuse. Fuse is a piece of Al wire, surrounded with glass and a window opening above. I apply power dissipation to it and calculate time-temperature chart. The problem is that I can't determine the point when my fuse is blown up. Any solutions on this? Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why my simulation not agree with the wind tunnel experiment | zhaowei | CFX | 4 | July 11, 2015 03:36 |
Solar Radiation in OpenFOAM | plainstyle | OpenFOAM Running, Solving & CFD | 15 | July 8, 2014 04:43 |
Axial fan simulation in UG/NX 7.5 | fan123 | Main CFD Forum | 2 | April 23, 2011 08:22 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 10:44 |
strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 13:02 |