|
[Sponsors] |
Problems encountered when setting up laminarSMOKE solvers |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 25, 2016, 15:28 |
Problems encountered when setting up laminarSMOKE solvers
|
#1 |
Member
Mingyuan Tao
Join Date: Mar 2016
Posts: 31
Rep Power: 10 |
Hi everyone,
I just encountered a problem as the following when setting up laminarSMOKE solver. make: *** [Make/linux64GccDPOpt/laminarSMOKE.o] Error 1 I set up the laminarSMOKE solve by following the instructions shown below: http://www.opensmoke.polimi.it/installation I do not know how to fix the problem, I do appreciate for your help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Direct vs Iterative Linear Solvers for non-linears | bill | Main CFD Forum | 16 | November 5, 2014 07:18 |
Problems in compiling solvers when using OpenFOAM13_11092006 | jin_xu | OpenFOAM Installation | 6 | July 2, 2010 12:34 |
Problems setting environment | bastil | OpenFOAM Installation | 7 | September 7, 2007 04:28 |
Problems with mesh motion in parallel | thomas | OpenFOAM Running, Solving & CFD | 3 | July 4, 2007 02:48 |
Problems setting up semitransparent media | Tim | FLUENT | 0 | March 8, 2001 02:49 |