|
[Sponsors] |
November 24, 2016, 13:23 |
Ribbed duct
|
#1 |
New Member
PALLABI
Join Date: Nov 2016
Posts: 8
Rep Power: 9 |
Hello everyone, i have a doubt about mesh size. Is is required that the mesh size of both smooth duct and ribbed duct should be same? I have a mesh size with inflation layers 13 for smooth duct. Is it necessary that the inflation layer of ribbed duct should also be 13? I tried, but the meshing fails for ribbed one.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
analyzing the temperature of fliud (air) flow inside an underground duct. | arshbunny | CFX | 9 | April 3, 2014 08:52 |
Getting (Nusselt vs Re) & (friction vs Re) in a ribbed duct | shayan_mv | FLUENT | 6 | November 14, 2012 03:42 |
Fabric Duct Modeling | Dan | FLUENT | 0 | June 30, 2008 15:00 |
modelling fuel cell duct in fluent | rajesh kumar tippabhotla | FLUENT | 2 | October 7, 2004 12:04 |
flow simulation across a small fan | jane luo | Main CFD Forum | 15 | April 12, 2004 17:49 |