|
[Sponsors] |
|
June 1, 2017, 12:24 |
volume correction
|
#1 |
New Member
Aravinth
Join Date: Mar 2017
Posts: 9
Rep Power: 9 |
hello everyone.. i need help.. i have been trying to set up single point mooring simulation in flow3d. but this error can keep on appearing in my simulation. how should i correct it?
1)pressure iteration did not converge in itmax= 100 iterations at time= 1.30126E-03 cycle= 1 iter= 100 delt= 1.30126E-03 epsi= 6.916E-02 maximum residual= 2.715E-01 at i= 221 j= 118 k= 33 block= 1 restarting cycle with smaller time-step size present relaxation factor omega= 6.707E-01 present time-step size delt= 1.301E-03 2) and how should i ensure the volume of water in my simulation to be maintain at the same value from beginning to the end of simuation. is there any specific way? hope you can help me out. thank you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
multiphaseEulerFoam high Courant number | Frenk_T | OpenFOAM | 5 | November 24, 2016 04:23 |
alphaEqn.H in twoPhaseEulerFoam | cheng1988sjtu | OpenFOAM Bugs | 15 | May 1, 2016 17:12 |
snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 11:58 |
dynamic Mesh is faster than MRF???? | sharonyue | OpenFOAM Running, Solving & CFD | 14 | August 26, 2013 08:47 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 06:42 |