|
[Sponsors] |
November 27, 2017, 06:26 |
Meshing and Skewness
|
#1 |
Member
Hells Blade
Join Date: Nov 2017
Posts: 61
Rep Power: 8 |
Hi
I want to check the air flow from my inlet(attached in the pic ) the 3 holes at the bottom represent my inlet approx 6 mm dia and at the top there is an opening which is the outlet . I basically need to see what difference would it make to the air flow when there are more inlets (3 or 5) or else the wall thickness is reduced in the current simuln it is 2 mm . My question while meshing how much should i tarket my skewnes the currently value i am getting is 0.8-0.9 whereas 0.25 is generally taken for better results kindly give your inputs ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Ansys meshing result very high skewness | m5edr | ANSYS Meshing & Geometry | 18 | February 3, 2020 11:35 |
[ANSYS Meshing] Fluent Meshing results in very high skewness | FFD | ANSYS Meshing & Geometry | 10 | August 31, 2017 11:09 |
Meshing - Skewness | CPegg | ANSYS | 0 | December 13, 2016 19:03 |
[ANSYS Meshing] Cutcell meshing and Its Skewness | oozcan | ANSYS Meshing & Geometry | 0 | August 10, 2016 01:46 |
[ICEM] How can i reduce the skewness in this meshing??? | gnut1989 | ANSYS Meshing & Geometry | 2 | January 6, 2015 05:03 |