|
[Sponsors] |
April 22, 2018, 05:20 |
2D BFS flow CFD
|
#1 |
New Member
anonymous
Join Date: Apr 2018
Posts: 26
Rep Power: 8 |
Hi there am trying to create a uniform mesh for a 2d turbulent step flow problem. I would like to accurately record the data for recirculation region after the step. To improve the mesh quality I decided to split the 2d step into faces and meshed each of them by manipulating edge sizing. However, when I use edge sizing to refine the mesh, I am unable to use inflation layers at the walls. This lead to an inaccurate simulation in fluent. Any ideas on how I could go about to get a very fine uniform mesh will wall inflations. Much appreciated as always
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to sumilate water flow of a river in a tunnel using Autocad CFD | Ashkar | Main CFD Forum | 0 | August 8, 2014 08:12 |
Edge association in ICEM CFD for compressor flow passage- Need help! | supermanks | ANSYS | 1 | February 19, 2014 00:39 |
PhD in turbulence | Hans | Main CFD Forum | 14 | October 8, 2001 03:03 |
ASME CFD Symposium - Call for Papers | Chris Kleijn | Main CFD Forum | 0 | September 25, 2001 10:17 |
ASME CFD Symposium - Call for Papers | Chris R. Kleijn | Main CFD Forum | 0 | September 8, 1998 08:19 |