|
[Sponsors] |
July 18, 2018, 18:20 |
problems in flow simulation
|
#1 |
New Member
Shahzad
Join Date: Jul 2018
Posts: 22
Rep Power: 8 |
Hello,
iam doing simulation on turbochrger compressor and i have a full turbochager ( compressor & turbine both) here my questions are: 1: if iam doing simulation on single part , should i enclose the whole part in domain or just a single part on which iam going to find results. 2. i have solid works 14 and got the same problems as mach num and supersonic flow , i just created wizard and i haven't did any meshing , just it meshes automatically . so please guide me , i will be very thank ful to you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SOLIDWORKS Flow Simulation | AnaE | FloEFD, FloWorks & FloTHERM | 9 | November 5, 2015 04:41 |
how to get a time-accurate solution in Flow Simulation | drdet | FloEFD, FloWorks & FloTHERM | 4 | January 20, 2015 08:11 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 11:44 |
Two-phase air water flow problems by activating Wall Lubrication Force | challenger85 | CFX | 5 | November 5, 2009 06:44 |
Natural convection - Inlet boundary condition | max91 | CFX | 1 | July 29, 2008 21:28 |