Simulate Vacuum Region Between Two Solid Bodies in ANSYS Fluent

Mohalatif · September 6, 2022, 09:10

Hi All,

I hope you are enjoying your time.

I am preparing a 2D simulation in ANSYS Fluent to simulate the heat transfer inside an empty box. Around this empty box, there are two solid boxes and one box with vacuumed pressure to provide insulation for the empty box and prevent heat transfer with the surrounding; please see the attached picture for more explanation.

https://ibb.co/qgywJ6w

My question is, am I able to simulate this case in ANSYS Fluent? If yes, how can I prepare the vacuum region between solid bodies in ANSYS?

I hope the explanation is clear and you got the idea.

Thank you in Advance.

LuckyTran · September 6, 2022, 11:45

Mesh everything. Give the real properties to the fluid in the vacuum region (air?) and set the pressure equal to the vacuum pressure. You can use a pressure inlet or outlet, I recommend a pressure inlet.

September 6, 2022, 09:10	Simulate Vacuum Region Between Two Solid Bodies in ANSYS Fluent	#1
Mohalatif New Member Mohammed Join Date: Sep 2022 Posts: 1 Rep Power: 0	Hi All, I hope you are enjoying your time. I am preparing a 2D simulation in ANSYS Fluent to simulate the heat transfer inside an empty box. Around this empty box, there are two solid boxes and one box with vacuumed pressure to provide insulation for the empty box and prevent heat transfer with the surrounding; please see the attached picture for more explanation. https://ibb.co/qgywJ6w My question is, am I able to simulate this case in ANSYS Fluent? If yes, how can I prepare the vacuum region between solid bodies in ANSYS? I hope the explanation is clear and you got the idea. Thank you in Advance. Last edited by Mohalatif; September 6, 2022 at 09:13. Reason: Attaching a picture

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Negative initial temperature error (chtMultiRegionFoam)	jebin	OpenFOAM Pre-Processing	60	July 17, 2022 05:10
ANSYS Fluent errors "Attach Failed" and "No Valid bodies Found"	Bertman	FLUENT	3	December 24, 2021 17:15
Problem simulating the temperature rise in a composite material (chtMultiRegionFoam)	Adam_K	OpenFOAM Running, Solving & CFD	2	March 27, 2019 06:51
Modeling vacuum suction through pipe in ANSYS Fluent	mamoody14	FLUENT	1	February 20, 2019 14:09
import to Ansys Fluent Design modeler shows 4141 parts and bodies	samnath	FLUENT	5	April 6, 2015 02:22

September 6, 2022, 11:45		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,682 Rep Power: 66	Mesh everything. Give the real properties to the fluid in the vacuum region (air?) and set the pressure equal to the vacuum pressure. You can use a pressure inlet or outlet, I recommend a pressure inlet.