|
[Sponsors] |
December 6, 2023, 23:09 |
maxdim_lst too small
|
#1 |
New Member
elena
Join Date: Dec 2023
Posts: 1
Rep Power: 0 |
Hi everyone, I am a new user of cfd software. Apparently, when i run my simulation about maneuvering, this problem occurred. I attached the photo of the crashed result. Hope someone can give me an idea about this problem. Thank you.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Meshing of a cylinder containing a small hole on one face | Giova82 | ANSYS Meshing & Geometry | 1 | August 12, 2015 06:49 |
patch a small field in flow | wu yu | FLUENT | 5 | April 9, 2014 16:45 |
SMALL value | C.C | FLUENT | 2 | November 1, 2013 05:07 |
small numerical fluctuations in the solution | nandiganavishal | OpenFOAM Running, Solving & CFD | 4 | June 18, 2013 03:01 |
why did Time step is too small in stiffbs? | satum | FLUENT | 1 | December 10, 2012 09:15 |