|
[Sponsors] |
December 5, 2010, 11:11 |
Mesh generation in impinging jets
|
#1 |
New Member
Shashank
Join Date: Jul 2010
Posts: 18
Rep Power: 15 |
I have been working on a jet impingement problem for a while now. I was trying to do a 2-d simulation on CFX using geometry and mesh from ICEM. But I am encountering problems with mesh generation. I am attaching pics in this post, so you can see my problem. Since cfx does not support 2d simulation, i have extruded my geometry by 1 unit in the z direction. So basically, you can see the various parts in the geometry. Inlet is a small c/s diameter part, whereas the rest are as mentioned. The jet enters through the inlet and impinges on the wall (green). But when I pre-mesh the set up, my mesh is very bad quality. Please advise.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
Mesh generation software is needed | H.Dou | Main CFD Forum | 12 | May 4, 2011 15:20 |
Mesh | Mignard | FLUENT | 2 | March 22, 2000 05:12 |