|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
bangun
Join Date: Feb 2015
Posts: 16
Rep Power: 11 ![]() |
Dear All,
I want to simulate a cylinder in a numerical wave tank and I've been using OF2.3.0. Previously I got no error when implementing this solver in a two-dimensional problem, but now in this 3D case, I have this following error: wrong token type - expected Scalar, found on line 0 the word 'nan'M FATAL IO ERROR: [23] wrong token type - expected Scalar, found on line 0 the word 'nan' [23] [23] file: /scratch1/ele12/OpenFOAM/a04f1v3/processor23/system/data.solverPerformance.p_rgh at line 0. file: /scratch1/ele12/OpenFOAM/a04f1v3/processor23/system/data.solverPerformance.p_rgh at line 0. In OF2.3.0, the p_rgh boundary condition imposed for a no-slip boundary is fixedFluxPressure, with value uniform 0. But often from a tutorial case of wave2foam, I noticed the p_rgh boundary condition imposed on a wall surface is zeroGradient. I think both terms have the same physical meaning. If not, could this be one of the reasons causing the above error? My mesh is okay as I did check the mesh. Could anyone give me a hint or suggestion please? Regards eb19 |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[waves2Foam] Mooring Lines waves2Foam How To | mhasif02 | OpenFOAM Community Contributions | 14 | May 24, 2024 11:35 |
[waves2Foam] combined set of waves with waves2Foam | blaise | OpenFOAM Community Contributions | 7 | December 16, 2023 08:33 |
[waves2Foam] waves2foam for of1706 | cfd_hchen | OpenFOAM Community Contributions | 0 | November 25, 2017 07:55 |
Segmentation fault running waveDyMFoam solver (mod. interDyMFoam solver - waves2Foam) | Ed R | OpenFOAM Running, Solving & CFD | 5 | July 2, 2013 11:36 |