|
[Sponsors] |
August 26, 2011, 11:18 |
cell geometry
|
#1 |
Member
David Aljure
Join Date: Mar 2011
Location: CTTC Universidad Politécnica de Catalunya. Spain
Posts: 38
Rep Power: 15 |
I've been working with snappyHexMesh for a while now, however, i've noticed that it creates cells and faces which are quite complex. Does anybody know how does OF calculate areas and volumes?
David |
|
August 29, 2011, 09:10 |
|
#2 |
Senior Member
Santiago Marquez Damian
Join Date: Aug 2009
Location: Santa Fe, Santa Fe, Argentina
Posts: 452
Rep Power: 23 |
Hi David, take a look of:
primitiveMeshCellCentresAndVols.C primitiveMeshFaceCentresAndAreas.C Regards.
__________________
Santiago MÁRQUEZ DAMIÁN, Ph.D. Research Scientist Research Center for Computational Methods (CIMEC) - CONICET/UNL Tel: 54-342-4511594 Int. 7032 Colectora Ruta Nac. 168 / Paraje El Pozo (3000) Santa Fe - Argentina. http://www.cimec.org.ar |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with building geometry - concentric cylinders | Rhoddwen | OpenFOAM Pre-Processing | 9 | December 17, 2014 10:02 |
Problem with geometry - concentric cylinders | Rhoddwen | OpenFOAM Running, Solving & CFD | 0 | December 15, 2014 09:22 |
[snappyHexMesh] snappyHexMesh failure to snap to geometry | Yadasol | OpenFOAM Meshing & Mesh Conversion | 1 | November 17, 2014 05:00 |
How to determine the direction of cell face vectors on processor patches | sebastian_vogl | OpenFOAM Running, Solving & CFD | 0 | October 27, 2009 08:47 |
vitual _ real | deneb | FLUENT | 3 | January 22, 2007 04:31 |