|
[Sponsors] |
March 23, 2014, 07:41 |
what does this error mean?
|
#1 |
New Member
Join Date: Mar 2014
Posts: 28
Rep Power: 12 |
Hi everybody!
Does anybody know what the following error message is about? ------------------------------------------------------------------------------------- Checking geometry... This is a 2-D mesh Overall domain bounding box (0 0 0) (0.001 0.001 0.001) Mesh (non-empty, non-wedge) directions (1 1 0) Mesh (non-empty) directions (1 1 0) Mesh (non-empty, non-wedge) dimensions 2 ***Number of edges not aligned with or perpendicular to non-empty directions: 2 Writing 4 points on non-aligned edges to set nonAlignedEdges Boundary openness (0 0 0) Threshold = 1e-06 OK. Max cell openness = 0 OK. Max aspect ratio = 2 OK. Minumum face area = 5e-07. Maximum face area = 1.41421e-06. Face area magnitudes OK. Min volume = 5e-10. Max volume = 5e-10. Total volume = 5e-10. Cell volumes OK. Non-orthogonality check OK. Face pyramids OK. Max skewness = 0.333333 OK. Failed 1 mesh checks. End ------------------------------------------------------------------------------------- I am trying to make a simple wedge type in OF1.6ext |
|
March 26, 2014, 05:21 |
|
#2 |
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 22 |
The One of your patches has wrong order of vertices. You can use 'foamToVTK -pointSet nonAlignedEdges' and then visualize the problem area with paraview.
|
|
|
|