 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] In need of guidance to optimize snappyHexMeshDict for a rotor segment |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 8, 2015, 01:14
|
In need of guidance to optimize snappyHexMeshDict for a rotor segment
|
#1 |
|
New Member
Zach
Join Date: Nov 2014
Posts: 6
Rep Power: 11  |
Hello,
I am trying to make snappyHexMesh for the following rotor segment with the following patches: https://www.dropbox.com/s/im59eo76bc...tches.png?dl=0 However, my current snappyHM setup: https://www.dropbox.com/s/ggjqomezqn...xMeshDict?dl=0 is not OK cause result mesh: https://www.dropbox.com/s/1uotklsyxb...0mesh.png?dl=0 is not suitable for simulation. How should I modify snappyHM setup to achieve smth like this: https://www.dropbox.com/s/b8ipmjgztx...0mesh.png?dl=0 ie I need more homogeneous mesh distribution especially at outlet and periodic faces. Thank you for any help! |
|
|
|
|
| Tags |
| snappy hex mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] howto optimize OpenFOAM for Core i7 CPU using extended instruction set | cutter | OpenFOAM Installation | 6 | December 28, 2015 20:19 |
| [snappyHexMesh] How to define the computational region with snappyHexMeshDict | xurenyi | OpenFOAM Meshing & Mesh Conversion | 3 | June 12, 2014 09:20 |
| [ANSYS Meshing] Request guidance on exporting mesh from ICEM to fluent | nauman55 | ANSYS Meshing & Geometry | 0 | February 16, 2013 10:54 |
Threaded Mode
