|
[Sponsors] |
[Gmsh] 2D Axisymmetic gird in gmsh to 3D grid? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 30, 2016, 03:23 |
2D Axisymmetic gird in gmsh to 3D grid?
|
#1 |
Member
OpenFoam
Join Date: Jun 2016
Posts: 82
Rep Power: 10 |
Hey All,
I have preformed a 2D axisymmetric simulations in openfoam using gmsh of the flow over a c-d nozzle. The simulation gave reasonable results when I validate it. My aim now is to create a full 3D mesh using the same meshing tool i.e. the same mesh that I created in 2D. I was wondering if there is any way to create a full 3d mesh using the same mesh using rotation. I have tried to rotate it but the problem is that the mesh got a little bit messy. Has anyone dealt with the same issue could give some hints? Thank you, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fluent LES model: grid requirement? | dinhanh | FLUENT | 1 | November 11, 2015 12:15 |
How to make grid for LES simulation | dinhanh | Main CFD Forum | 3 | November 11, 2015 02:37 |
Grid Adaptation | Suresh | FLUENT | 0 | October 15, 2003 13:18 |
GRID TO GRID INTERPOLATION in FLUENT | calogero | FLUENT | 3 | June 4, 2003 08:32 |
Numerical methods for discontinuous grid interfaces? | Hansong Hang | Main CFD Forum | 12 | September 16, 1998 22:26 |