|
[Sponsors] |
August 26, 2016, 12:56 |
Parametric Multigrading
|
#1 |
New Member
Mauricio Aguilar
Join Date: Jul 2016
Posts: 15
Rep Power: 9 |
Hello foamers,
I'm using an extra file (parameters) to source all my variables into blockMeshDict and topoSetDict so I can easily adjust my geometry. I have just finished including the multigrading section in BlockMeshDict and I'm getting supper weird results when including variables from "parameters"...if I define all multigrading parameters this way I even get a seg-fault. Using some hardcoded values allows blockMesh to solve but it does so with weird values. Is there something similar to Printf with which I can print my variables after they were parsed? I'm looking for a way to debug my code. I have included my blockMeshDict and parameters file in case anyone wants to give it a try. In blockMeshDict lines [42-47] i've hardcoded the values that should come from the calculated parameters established in parameters lines [117-123]. I've commented out the solution I would like to employ. blockMeshDict.txt parameters.txt Any help is greatly appreciated. kind regards, Mauricio |
|
Tags |
blockmesh, debug, multigrading, parameterization, printf |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parametric study by Ansys Workbench | Sahar FaPerhu | ANSYS | 17 | August 23, 2017 03:29 |
Problem with Parametric Study | Picopico | CFX | 1 | March 7, 2017 17:56 |
[ICEM] Parametric O-grid and Parametric Split | Henry Arrigo | ANSYS Meshing & Geometry | 3 | October 20, 2014 05:32 |
parametric study with design modeler and icepak | aminem | ANSYS | 3 | May 21, 2014 05:11 |
Comsol (4.3): convert parametric surface into block? | sgalaz | COMSOL | 0 | November 9, 2012 09:20 |