CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[Other] Failed 2 mesh checks

Register Blogs Community New Posts Updated Threads Search

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   April 27, 2017, 17:29
Default Failed 2 mesh checks
  #1
Senior Member
 
sandy
Join Date: Feb 2016
Location: .
Posts: 117
Rep Power: 10
saddy is on a distinguished road
I am trying to create axisymmetric 2-d case for flow inside VERTICAL CYLINDER. i am creating a wedge of 2.5 degree with two zones inside. a (cylinder) inner zone for gas and thin liquid film near outer cylinder wall but i am unable to get rid of error regarding highly aspect ratio mesh and non aligned cells due to small angle of 2.5 degree. any solution??

Checking geometry...
Overall domain bounding box (0 0 -0.000261779) (0.012 0.2 0.000261779)
Mesh (non-empty, non-wedge) directions (1 1 0)
Mesh (non-empty) directions (1 1 1)
Wedge front with angle 1.25 degrees
Wedge back with angle 1.25 degrees
***Number of edges not aligned with or perpendicular to non-empty directions: 239520
<<Writing 120242 points on non-aligned edges to set nonAlignedEdges
Boundary openness (-6.00434e-18 4.22958e-17 -7.1526e-16) OK.
***High aspect ratio cells found, Max aspect ratio: 599952, number of cells 60000
<<Writing 60000 cells with high aspect ratio to set highAspectRatioCells
Minimum face area = 1.21203e-12. Maximum face area = 3.33333e-05. Face area magnitudes OK.
Min volume = 2.42407e-13. Max volume = 2.88464e-11. Total volume = 6.28319e-07. Cell volumes OK.
Mesh non-orthogonality Max: 1.70755e-06 average: 0
Non-orthogonality check OK.
Face pyramids OK.
Max skewness = 0.333333 OK.
Coupled point location match (average 0) OK.

Failed 2 mesh checks.
saddy is offline   Reply With Quote

Reply

Tags
failed mesh checks, not aligned


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
how to set periodic boundary conditions Ganesh FLUENT 15 November 18, 2020 07:09
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! sc298 OpenFOAM Meshing & Mesh Conversion 2 March 27, 2011 22:11
[blockMesh] Failed 1 Mesh checks !! ? T.D. OpenFOAM Meshing & Mesh Conversion 3 February 24, 2011 18:39
[OpenFOAM] ParaView/Parafoam error when making animation Disco_Caine ParaView 6 September 28, 2010 10:54
fluent add additional zones for the mesh file SSL FLUENT 2 January 26, 2008 12:55


All times are GMT -4. The time now is 19:54.