|
[Sponsors] |
[mesh manipulation] CreatePatchDict & TopoSet. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 26, 2019, 06:04 |
CreatePatchDict & TopoSet.
|
#1 |
New Member
Stefano Doddo
Join Date: Mar 2019
Posts: 7
Rep Power: 7 |
Hi everyone, this is the first time for me here, my name is Stefano and it's a pleasure for me. I'm studying a heat flux method and i have to simulate it with openfoam. I found a case in openfoam that reproduce an adiabatic burning flame to study the adiabatic burning velocity, "counterflowflame_2D" and i modified it in HF, but I have some problem with the definition of the mesh. The volume to define is a single block with the inlet at the bottom and the outlet in the others part but there is two snippets (2 mm high) at the bottom to define like wall (no inlet, no outlet) at the fixed temperature. So, to do this, I used the method present in the case "smallPoolFire2D", with createpatchDict and topoSet, and I modified it for two patches, you can see the script in the corresponding attached files, where you can find, also, the OpenFoam error after the launching createPatch command. Can someone help me? Have you got some suggestions?
Thank you so much for yours attention. Best Regards. Stefano. |
|
Tags |
createpatchdict, heat flux model, help in mesh, mesh, toposetdict |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fail to run series of runApplication topoSet -dict | jiahui_93 | OpenFOAM Programming & Development | 1 | May 25, 2022 12:56 |
creating square patch (for air inlet) on the bottom face using cellset in toposet | Rajesh Nimmagadda | OpenFOAM Running, Solving & CFD | 0 | October 31, 2017 12:27 |
[snappyHexMesh] Porous Media using TopoSet | RobertoCirolini | OpenFOAM Meshing & Mesh Conversion | 3 | August 30, 2016 08:34 |
[Other] topoSet Wrong number of faces. | a19910112a | OpenFOAM Meshing & Mesh Conversion | 1 | June 9, 2015 05:41 |
[snappyHexMesh] HOW to set a circular face by toposet | Jessica | OpenFOAM Meshing & Mesh Conversion | 2 | September 12, 2013 20:54 |