 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Can not produce clean mesh at sharp edges |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 20, 2019, 10:39
|
Can not produce clean mesh at sharp edges
|
#1 |
|
New Member
Febrian Akhmad Baehaqi
Join Date: Jul 2019
Location: Bandung
Posts: 5
Rep Power: 6  |
Hi guys, I'm new to OpenFOAM and still learning about it. So I got a problem here. I'm trying to mesh a wing with sharp trailing edge using snappyHexMesh. But It seems that I can not produce a clean mesh at the trailing edge and keep getting jagged trailing edge.
Here are the screenshot and the snappyHexMeshDict that I used. I try to keep the skewness of the mesh as low as possible to keep the accuracy of the results. Thank you, best regard from me. I appreciate all your answers. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Multi Region Mesh of a car filter | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 3 | September 11, 2019 19:34 |
| [snappyHexMesh] SHM problem : KVLCC2 with appendage mesh | sc.park | OpenFOAM Meshing & Mesh Conversion | 1 | March 13, 2016 13:28 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Threaded Mode
