 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] distorting internal mesh on a pipe when snapping |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 2, 2020, 12:49
|
distorting internal mesh on a pipe when snapping
|
#1 |
|
New Member
Join Date: Dec 2020
Posts: 15
Rep Power: 5  |
Hello,
I am trying to run an MPPIC simulation on a pipe but have ran into an issue that is new to me when trying to generate the mesh. My block mesh is roughly square and when i run snappy the first pass before snapping the mesh after removing external cells is still nicely orthogonal inside. however after it snaps the mesh to the surface it is creating highly distorted areas inside of the mesh (surface mesh is still good). I have tried messing with a bunch of the mesh quality setting and increasing the surface refinement on my geometry but can't seem to get it to work. Has anyone ran into this before/know how to fix it? Thanks, |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |
| Too diffusive result on Delaunay type mesh for pipe | AlmostSurelyRob | OpenFOAM Running, Solving & CFD | 7 | October 8, 2018 13:34 |
| [snappyHexMesh] Snapping not enough (even with surfaceFeatureExtract) | ironclad | OpenFOAM Meshing & Mesh Conversion | 1 | November 8, 2013 02:58 |
| [GAMBIT] 3D mesh for pipe intersection | pranab_jha | ANSYS Meshing & Geometry | 3 | May 28, 2010 01:33 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Threaded Mode
