 |
 |
 |
|
|
|
[Sponsors] | ||||
July 24, 2022, 04:35
|
refinement
|
#1 |
|
New Member
Shai Aser
Join Date: Aug 2015
Posts: 25
Rep Power: 10  |
Hi,
I could really use some insight as to what may cause the cell castellated mesh refinement to be this 'patchy' (see attached image). any suggestions will be most welcome Shai |
|
|
|
|
|
July 25, 2022, 01:48
|
|
#2 |
|
Senior Member
Nejc
Join Date: Feb 2017
Location: Slovenia
Posts: 196
Rep Power: 9 |
a) You have different levels set for this feature and resolveFeatureAngle governs when it's refined and when not.
b) surfaceFeatureExtract creates edge mesh with missing regions. You can check that with foamFormatConvert to convert to .obj then open in paraview. |
|
|
|
|
|
|
July 25, 2022, 05:27
|
|
#3 |
|
New Member
Shai Aser
Join Date: Aug 2015
Posts: 25
Rep Power: 10 |
thank you kandelabr !
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh running killed! | Mark JIN | OpenFOAM Meshing & Mesh Conversion | 7 | June 14, 2022 01:37 |
| problem with parallel calculations OF8 mpirun | otaolafr | OpenFOAM Programming & Development | 0 | January 5, 2021 07:33 |
| SimpleFoam & Theater | jipai | OpenFOAM Running, Solving & CFD | 3 | June 18, 2019 10:11 |
| killed "snappyHexMesh" | parkh32 | OpenFOAM Pre-Processing | 2 | April 8, 2012 17:12 |
| [snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
Linear Mode
