|
[Sponsors] |
April 2, 2023, 10:03 |
Optimize repeating mesh
|
#1 |
New Member
Gustavo
Join Date: Jun 2021
Posts: 17
Rep Power: 5 |
Hello,
I need to simulate the flow of water over the attached spillway. The pattern on the inside repeats 12 times, but the borders are slightly different. Is there a way to optimize this mesh? Avoiding simulating some of the internal patterns. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
[snappyHexMesh] High quality mesh for wind in complex urban environment | ziboaa | OpenFOAM Meshing & Mesh Conversion | 1 | January 12, 2021 16:33 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 06:38 |
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 06:03 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |