|
[Sponsors] |
[snappyHexMesh] How to select this face as the inlet bc. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 24, 2023, 23:37 |
How to select this face as the inlet bc.
|
#1 |
Senior Member
|
I use the following stl file for the snappyMesh. but i need to set the inlet bc as shown in the picture.
Could you please give me some advices about how to select this face. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OLAFLOW] The OLAFLOW Thread | Phicau | OpenFOAM Community Contributions | 457 | March 27, 2024 00:59 |
[ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 14:18 |
Simulating fire in a tunnel | luca1992 | OpenFOAM | 14 | August 16, 2017 13:50 |
[snappyHexMesh] How to define to right point for locationInMesh | Mirage12 | OpenFOAM Meshing & Mesh Conversion | 7 | March 13, 2016 14:07 |
assign transient random data to inlet face | colopolo | FLUENT | 26 | July 24, 2013 23:02 |