[mesh manipulation] Mesh Refinement - Page 2 -- CFD Online Discussion Forums

March 2, 2005, 14:44	Mesh Refinement	#1
Luiz Eduardo Bittencourt Sampaio (Sampaio) Guest Posts: n/a	Has anyone done mesh refinement in FOAM? Can someone tell me what are the steps involved? (Once I generated a refined mesh, but it was written separetely in a "time" dir, and I did not know what to do next to incorporate that in the original one. I just come back to this problem again, so if someone can tell me the general steps...) I am particularly interested in refining a region of my domain, preserving hex volumes topology, so that I will have some hanging nodes in the end... Best Regards, Luiz

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] snappyHexMesh sticking point	natty_king	OpenFOAM Meshing & Mesh Conversion	11	February 20, 2024 09:12
y+ = 1 boundary layer mesh with snappyHexMesh	Arzed23	OpenFOAM Running, Solving & CFD	6	November 23, 2022 15:15
[snappyHexMesh] Edge Refinement	fracasce	OpenFOAM Meshing & Mesh Conversion	3	December 2, 2017 13:30
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer	Sunxing	OpenFOAM Meshing & Mesh Conversion	9	September 20, 2014 09:30

All times are GMT -4. The time now is 03:49.