|
[Sponsors] |
November 23, 2008, 21:24 |
Volume mesh instead of surface mesh
|
#1 |
New Member
Stephan Koerner
Join Date: Mar 2009
Posts: 4
Rep Power: 17 |
Hello,
I want to mesh a stl file but any time I try Netgen creates a surface mesh. At the beginning I thought that the volume mesh is just not shown when I used the clipping function because it did only show an empty inside. But I was not able to convert the mesh to the foam format. That's why I guess that the mesh information is not adequate (not a volume). It always shows the message: "Trying to get back from bad stream" Is there a way to mesh a volume out of a surface mesh or from a stl file with Netgen or any other Mesher? Thanks a lot! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[snappyHexMesh] Help with Snappy: no layers growing | GianF | OpenFOAM Meshing & Mesh Conversion | 2 | September 23, 2020 08:26 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |