|
[Sponsors] |
January 4, 2011, 13:55 |
Mesh outiside an obstacle
|
#1 |
Senior Member
Andrea Ferrari
Join Date: Dec 2010
Posts: 319
Rep Power: 16 |
Hi all,
i have a little problem with gmsh. i would like to do a geometry with some hole or obstacle (suppose a square with a circle inside for simplicity, 1 cell in z direction) but i would like to create the mesh only outside the hole (so in the volume between the square and the circle). Is possible? At the end i dont know if for OF is a real problem because the patch on the surface of the circle is "wall" so nothing enter in the circle but i would like to do that anyway (if i build up a movie of the simulation i dont want to see the mesh inside the hole). Thanks a lot Andrea |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |