 |
 |
 |
|
|
|
[Sponsors] | ||||
June 13, 2011, 16:15
|
HRSG Simulation
|
#1 |
|
New Member
Hassaan Rafi
Join Date: Jun 2011
Posts: 7
Rep Power: 14  |
I have made the geometry and have meshed it in Gambit (in 2D ).
I applied the boundary zones in the following way. 1. Water Pipes -- Wall BC. 2. One Edge as --Mass Flow Inlet 3. another edge as --Pressure Outlet When i export it to Fluent, it loads properly but when i go to specify the boundary conditions at these zones. The 'mass flow inlet' and 'pressure outlet' zones are not listed there. May i add i am new to CFD. So, your help will be greatly appreciated. Its my final year project. Thanks in advance. Last edited by hassaan; June 14, 2011 at 02:28. |
|
|
|
|
| Tags |
| boundary condition, fluent 12.0, gambit 2.4.6, hrsg |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Convergence Problem - Transient Simulation | gemxx | Main CFD Forum | 0 | July 15, 2018 09:36 |
| Mapping Field Data for Mesh Regions from Another Simulation | veterator | OpenFOAM Pre-Processing | 1 | July 10, 2018 05:28 |
| Surface Source - Fixed Temperature? | robtheslob | FloEFD, FloWorks & FloTHERM | 18 | May 12, 2017 02:28 |
| Simulation FPEs - turbulence for transient and steady-state? | DaveR | OpenFOAM Running, Solving & CFD | 5 | March 5, 2017 15:06 |
| setting up a simulation with multiple interactions | phandy | OpenFOAM Running, Solving & CFD | 1 | October 6, 2014 03:16 |
Threaded Mode
