|
[Sponsors] |
[snappyHexMesh] Boundary layer grid for Wigley hull by snappyHexMesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 30, 2011, 07:28 |
Boundary layer grid for Wigley hull by snappyHexMesh
|
#1 |
New Member
nbak skmt
Join Date: Nov 2011
Posts: 5
Rep Power: 14 |
Dear all,
Hello, I'm working on grid generation around Wigley hull using snappyHexMesh. The code version and working environment is OpenFOAM 2.0.1 under Ubuntu 10.04LTS (64bit). The case I'm trying to modify is: /tutorials/multiphase/LTSInterFoam/wigleyHull For the default run (i.e. don't modify anything written in "snappyHexMeshDict" in the tutorial directory), I have no problem and can view mesh by paraFoam. When I tried to insert boundary layer mesh by using "addLayers" as well as modifying "addLayersControl" parameters , mesh has been created in 4 steps, i.e. \0: Mesh by blockMeshDict \1: Before snap \2: After snap \3: After inserting boundary layer mesh In log.snappyHexMesh, I don't see any error message and checkMesh tool doesn't show error message neither. Yet the mesh in \2 and \3 looks identical, in other words, no boundary layer mesh is inserted. Has anyone encountered such problem? Any comments to figure out this problem will be greatly appreciated. I'm also ready to upload my snappyHexMeshDict as well as relevant files to somewhere if necessary. Thanks in advance for your help. Best wishes, Novak |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
[snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
[snappyHexMesh] Problem airfoil snappyhexmesh add layer | bye bye my blue | OpenFOAM Meshing & Mesh Conversion | 1 | May 5, 2017 05:56 |