|
[Sponsors] |
May 24, 2018, 05:15 |
Water creation in multiphase
|
#1 |
New Member
Join Date: May 2018
Posts: 14
Rep Power: 8 |
Hello,
I'm working on a air-water separator with water particles in air. When i use twoPhaseEulerFoam to simulate my problem, and I study the volume flow rate, I obtain: https://ibb.co/nhPYO8 The percentage corresponds to the volume flow difference between the inlet and the two outlets and in horizontal we have the number of mesh. Its normal to have changes depending on the speed but is it normal to have a negative validation percentage (water creation)? Tank you for my your help and sorry for my bad english. Have a good day. Last edited by Jeneas; May 25, 2018 at 05:19. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water diffusion into air | MGabr | CFX | 19 | September 3, 2023 19:06 |
No liquid water exist in my Fuel Cell simulation | fatchang | FLUENT | 19 | October 15, 2018 14:27 |
calculate for water phase in multiphase | congsu | FLUENT | 0 | April 30, 2012 23:03 |
IAPWS water properties + orthotropic thermal conductivity | Chander | CFX | 1 | February 29, 2012 17:26 |
Separation phenomenon of water, droplet and air | Raymond | CFX | 0 | July 9, 2004 22:59 |