|
[Sponsors] |
Creating and postprocessing a rotational surface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 20, 2008, 10:34 |
Hello all,
I need to create
|
#1 |
Guest
Posts: n/a
|
Hello all,
I need to create a rotational surface inside my domain at a fixed radius and perform some calculations on it - like calculating and averaging radial/tangential velocities and pressure. As far as I can see it is not possible to postprocess cylindrical planes with sample. I did not manage to create a cylindrcal cut in ParaView either... Any advice would be greatly appreciated. Thanks in advance, Paul PS: I'm quite new to OF and not very experienced in C++. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Creating Lagrangian particles for postprocessing | hjasak | OpenFOAM Post-Processing | 6 | July 2, 2008 10:59 |
postprocessing - surface - plane | Brujo | FLUENT | 2 | March 1, 2008 10:36 |
GUI-Postprocessing : Iso-surface reusable | PK | FLUENT | 0 | August 2, 2006 06:39 |
UDF using data from postprocessing surface | Cedric | FLUENT | 2 | August 1, 2005 11:16 |
!!!PostProcessing - Free surface!!! | Segersson David | Siemens | 3 | August 1, 2002 06:58 |