|
[Sponsors] |
May 4, 2016, 00:33 |
Iterative boundary condition
|
#1 |
Member
Zhiheng Wang
Join Date: Mar 2016
Posts: 72
Rep Power: 10 |
I have gone through all your suggestions about egassing BC I am trying to built BC based on Evaporation.
I am writting an interface condition for inlet where liquid converts to gas Method is very simple 1. first i have assume inlet temp 10k below boiling temp say Ts=290 and Tb=300 2.Then calculation XFs=exp((-hfg*Mw/Ru)((1/Ts)-(1/Tb)) Basic Clausious Claeperon hfg latent heat , Ru gas constant, Mw molecular weight of liquid. 3.Using Xfs we can find Yfs=(Xfs*Mw)/Mw,mix , Mw,mix is molecular weight of liquid 4.By using Yfs we can calculate velocity Us=diff*(gradYf)/(1-Yf). 5.We check that our assumed Ts value is right or not using gradTs = rho*Us*hfg/k. If assumed Ts is write, Ts will be the boundary condition temp of inlet else it will go to re-iterate. until Ts=0.98Tb. I can also send you code of c++ i tried and code of codestram can you plz help regarding this. Can we use for loop in groovy BC??? please send your valuable suggestions Regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Accessing multiple boundary patches from a custom boundary condition file | ripudaman | OpenFOAM Programming & Development | 0 | October 22, 2014 18:34 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |