|
[Sponsors] |
April 19, 2021, 22:11 |
openfoam Enthalpy Reference Temperature
|
#1 |
Senior Member
|
How to set the openfoam Enthalpy Reference Temperature. Could you pleas give me some suggestoins about the defaults values.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Reference Pressure and mass flow inlet boundary | AdidaKK | CFX | 75 | August 20, 2018 05:37 |
Ansys CFX problem: unexpected very high temperatures in premix laminar combustion | faizan_habib7 | CFX | 4 | February 1, 2016 17:00 |
Compression stoke is giving higher pressure than calculated | nickjuana | CFX | 62 | May 19, 2015 13:32 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
Building OpenFoAm on SGI Altix 64bits | anne | OpenFOAM Installation | 8 | June 15, 2006 09:27 |