|
[Sponsors] |
March 29, 2012, 05:09 |
Problems with Probes
|
#1 |
New Member
Marwan Sabih
Join Date: Jun 2011
Posts: 8
Rep Power: 14 |
Hello Openfoamers,
does anyone know how to set the precision of the time, written in the probe-folders, if you probe the U and the p- Fields. At the moment it writes out only with the precision of 0.1: 36535.2 (0.0420636 0.00180577 0.000343072) 36535.2 (0.0420595 0.00180536 0.000346606) 36535.2 (0.0420553 0.00180495 0.000350141) 36535.2 (0.0420512 0.00180454 0.000353673) 36535.2 (0.0420471 0.00180412 0.000357204) 36535.2 (0.042043 0.0018037 0.000360731) 36535.2 (0.0420389 0.00180327 0.000364257) 36535.3 (0.0420347 0.00180284 0.00036778) 36535.3 (0.0420306 0.00180241 0.0003713) 36535.3 (0.0420265 0.00180198 0.000374818) 36535.3 (0.0420224 0.00180154 0.000378335) 36535.3 (0.0420182 0.00180109 0.000381848) 36535.3 (0.0420141 0.00180065 0.000385359) Changing this Precions from 6 to 9 hadn't helped. writePrecision 9; writeCompression uncompressed; timeFormat general; timePrecision 9; Greetings LeFrog |
|
March 29, 2012, 12:10 |
|
#2 |
New Member
Marwan Sabih
Join Date: Jun 2011
Posts: 8
Rep Power: 14 |
Problem solved - OpenFoam can't change the timePrecision while running - so there is no problem...
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
Needed Benchmark Problems for FSI | Mechstud | Main CFD Forum | 4 | July 26, 2011 12:13 |
Error using probes | balkrishna | OpenFOAM Running, Solving & CFD | 6 | November 12, 2010 04:55 |
problems with probes() function in chtMultiRegionFoam | Victor | OpenFOAM | 0 | November 25, 2009 15:08 |
Some problems with Star CD | Micha | Siemens | 0 | August 6, 2003 13:55 |