|
[Sponsors] |
Issue of falling level of continuous media when bubbles injected |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 22, 2016, 04:56 |
Issue of falling level of continuous media when bubbles injected
|
#1 |
Senior Member
Manu Chakkingal
Join Date: Feb 2016
Location: Delft, Netherlands
Posts: 129
Rep Power: 10 |
Hello
I have a case where interfoam solver was modified with kinematic cloud inclusions to take in consideration of bubbles introduced at bottom of a rectangular patch inlet of a rectangular domain.The initial field is set so that we have a layer of liquid (water) from bottom to a fixed height and air filled in from that height to top of the domain. When I do the simulations with the boundary conditions( attached herewith) the level of liquid falls down. Is it any issue with BCs given?bubblrinterfoam_calc.zip Screenshot from alpha_bubble_half_time.ogv.jpg Screenshot from alpha_bubble_half_time.ogv - 2.jpg Screenshot from alpha_bubble_half_time.ogv - 3.jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Porous media setup issues in Fluent | Bernard Van | FLUENT | 29 | January 26, 2017 04:09 |
Flow through porous media: permeability issue | butterfly1 | Main CFD Forum | 1 | January 2, 2014 02:34 |
Flow through porous media: permeability issue | butterfly1 | CFX | 3 | December 23, 2013 21:23 |
[snappyHexMesh] Adding layers goes wrong with SnappyHexMesh | Elise | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 02:32 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |