 |
 |
 |
|
|
|
[Sponsors] | ||||
February 20, 2016, 01:34
|
I'm newbie in OpenFoam plz help
|
#1 |
|
New Member
Porya Morovati NilaorE
Join Date: Dec 2015
Posts: 1
Rep Power: 0  |
Dear friends,
I'm trying to simulate fluid flow around a 2D groyne (1 phase, turbulent flow). Would you plz share your experiments with me? I'm using interFoam solver and I would like to know about: RAS, nut, nutilda and omega parameters Plz also share needed resources Thanks 
|
|
|
|
|
|
March 15, 2016, 03:41
|
|
#2 |
|
Member
Join Date: Aug 2014
Location: Germany
Posts: 77
Rep Power: 11 |
Hi,
I was actually searching for interfoam and your question came up. As I understand, interfoam is used in case of multiphase flows. Why are you using it if its a single phase flow that you are simulating ? I'm also new to openfoam, so there are chances I can be wrong..!! 
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Map of the OpenFOAM Forum - Understanding where to post your questions! | wyldckat | OpenFOAM | 10 | September 2, 2021 05:29 |
| Quick OpenFoam to MatLab lesson plz :) | Rickard.Solsjo | OpenFOAM | 6 | October 26, 2020 11:58 |
| Memory protection in OpenFOAM / combinig with FORTRAN | botp | OpenFOAM Programming & Development | 2 | February 15, 2016 12:25 |
| OpenFOAM Training Pilot Sessions June 2015 | cfd.direct | OpenFOAM Announcements from Other Sources | 0 | April 8, 2015 17:26 |
| [Gmsh] gmsh 2.6.0 conversion to OpenFoam 160 | rosswin | OpenFOAM Meshing & Mesh Conversion | 0 | March 5, 2013 07:34 |
Linear Mode
