 |
 |
 |
|
|
|
[Sponsors] | ||||
How to inject particles from specific points with different injection rate |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 6, 2016, 08:38
|
How to inject particles from specific points with different injection rate
|
#1 |
|
Member
Bijan Darbari
Join Date: Nov 2015
Posts: 48
Rep Power: 10  |
Dear all
I'm using DPMFoam solver and I want to inject particles from specific points with different injection rates in each point. How can I do that?? note: In "kinematic lookup table injection", particles inject from specific points but with the same injection rate. In my case, I want to inject them with different injection rates ( point 1 with rate 1, point 2 with rate 2, ..., point n with rate n) Best wishes |
|
|
|
|
|
March 7, 2018, 13:14
|
|
#2 |
|
Member
Join Date: Oct 2015
Posts: 63
Rep Power: 10 |
Hi Bijan,
Did you manage to solve this issue? Even I want to inject particles with different injection rates. Best, Scram_1 |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Use flow rate calculated from an function object in an injection model | ttjs3 | OpenFOAM Programming & Development | 2 | June 7, 2016 09:52 |
| loop over all injection streams in order to get the particles specifications | alighaffari | Fluent UDF and Scheme Programming | 0 | August 28, 2012 01:42 |
| Unsteady Injection (DPM) for certain amount of particles | Gold | FLUENT | 0 | October 18, 2011 13:15 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
Linear Mode
