Error by "yPlus" Terminal input version 4.1 PipeFlow

OpenFOAM_rokie · February 26, 2017, 10:35

Hello OpenFOAM users,

we have started in the University with OpenFOAM. We have to simulate a PipeFlow. Therefore i want to look for my yPlus. Used is the simpleFoam solver. By typing "yPlus" in the terminal i get this error.

Bildschirmfoto vom 2017-02-26 16-27-16.png

May if you know why i can´t see the yPlus could you help me.

LThomes · July 10, 2017, 07:45

This message tells you that the call of the command "yPlus" has been "modified" in your OpenFOAM version. So, you have to type

Code:

simpleFoam -postProcess -func yPlus

February 26, 2017, 10:35	Error by "yPlus" Terminal input version 4.1 PipeFlow	#1
OpenFOAM_rokie New Member Fabian Join Date: Feb 2017 Location: Germany Posts: 1 Rep Power: 0	Hello OpenFOAM users, we have started in the University with OpenFOAM. We have to simulate a PipeFlow. Therefore i want to look for my yPlus. Used is the simpleFoam solver. By typing "yPlus" in the terminal i get this error. Bildschirmfoto vom 2017-02-26 16-27-16.png May if you know why i can´t see the yPlus could you help me.

July 10, 2017, 07:45		#2
LThomes Member Join Date: May 2017 Posts: 47 Rep Power: 9	This message tells you that the call of the command "yPlus" has been "modified" in your OpenFOAM version. So, you have to type Code: simpleFoam -postProcess -func yPlus

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to input and run a case from earlier version to new version of openFOAM?	mamalili	OpenFOAM Running, Solving & CFD	2	January 30, 2015 04:03
[OpenFOAM] Paraview 3.98 - errors when saving geometry file	pajot	ParaView	1	September 28, 2013 10:45
paraview installation woes	vex	OpenFOAM Installation	15	January 30, 2011 07:11
OpenFOAM-1.6 install cookbook	MadsR	OpenFOAM Installation	372	November 20, 2010 11:57
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41