|
[Sponsors] |
Distributed Parallel with Windows Subsystem for Linux |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 5, 2019, 00:03 |
Distributed Parallel with Windows Subsystem for Linux
|
#1 |
Member
Ndong-Mefane Stephane Boris
Join Date: Nov 2013
Location: Kawasaki (JAPAN)
Posts: 53
Rep Power: 12 |
Hello,
I am trying to run the cavity example using two nodes (it works on both nodes in single node mode...), but I am having the problem similar described below: - When I run: mpirun --hostfile machines -np 4 icoFoam -parallel the application just hangs without any error message. - When I try from node1: ssh node2 "icoFoam -help" I get the following error message "bash: icoFoam: command not found" Openfoam v1906 is installed on both nodes, the command "icoFoam -help" works when run on each node, and simple commands such as "ssh node2 'ls' " ran from node1 give the expected result. I am using windows10 WSL Is it possible to use OpenFoam distributed parallel on WSL nodes? if yes, How??? help please!!! Kazunobu |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Explicitly filtered LES | saeedi | Main CFD Forum | 16 | October 14, 2015 11:58 |
Where to find parallel v4.0 for Windows? | aberkk | SU2 Installation | 1 | September 15, 2015 16:31 |
Running CFX parallel distributed Under linux system with loadleveler queuing system | ahmadbakri | CFX | 1 | December 21, 2014 04:19 |
Need help parallel in windows 7 | fluidmechanics | SU2 Installation | 2 | June 14, 2013 05:15 |
PVM RSH parallel setup problem Windows XP | abe | CFX | 11 | January 30, 2006 05:10 |