[DanPad07]

Hi all,

I've got a curious error in my simulation. The simulation will stop running at an early time step and exit without giving an error or explaining why. I began running this in parallel and the only erroneous line displayed was:

[58] #0  Foam::error::printStack(Foam::Ostream&)

I tried running this in series and instead I just got no message whatsoever about why the simulation stopped running.

This error only occurred when I increased my mesh element density from 175x315x42 to 200x360x48. The simulation worked for the former but not the latter which leads me to believe that it is a meshing problem. But when I use checkMesh it says that it only failed one test and I believe it was because of concave faces/cells.

I've attached my case below (some files, like the stl file, were removed due to the max file size) so if anyone could give me any indication as to why this is happening I would greatly appreciate it.

Thanks,
Dan