|
[Sponsors] |
June 10, 2021, 13:10 |
Stepped Channel
|
#1 |
New Member
Gustavo
Join Date: Jun 2021
Posts: 17
Rep Power: 4 |
Hello Everyone,
I am trying simulate a stepped channel using the example multiphase/interFoam/RAS/weirOverflow. So I modificated the blockMeshDict file to represent de steppeds. But when I run the simulation, the water dont enter in region after the stepped (how can be seen in the attached picture). How can I allowed that the fluid enter in this region? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D open channel hydraulic jump would not jump | roi247 | FLUENT | 3 | March 11, 2020 03:46 |
Enabling Open Channel Flow Sub-Model in Mixture model | cod213 | FLUENT | 0 | January 10, 2017 13:40 |
Open Channel Flow | ElanMorin | FLUENT | 4 | February 25, 2015 16:26 |
interFoam Micro channel | 1988 | OpenFOAM Running, Solving & CFD | 1 | January 25, 2015 13:50 |
Question on the boundary condition for open channel flow, please help! | ripperjack | OpenFOAM Running, Solving & CFD | 0 | September 13, 2013 11:44 |