How to set a tangential-only velocity boundary condition

bobuhito · January 12, 2022, 15:37

I'm running a 2D transient flow simulation and have a flat patch at which I would like to force a pressure of 0 and tangential velocity of 0 (leaving normal velocity free, and gradients free, for the solver to calculate at each time step). If the flow were into the block, I know "type pressureInletOutletVelocity" works perfectly for this, but in the outflow case, for better convergence, this type does not constrain the tangential velocity. I don't think my case will have a convergence problem and would prefer to just keep the tangential constraint for both directions.

At the most basic level, I just want the reversed constraint of "type fixedNormalSlip" which has normal velocity fixed but tangential velocity free. So, I am looking for the equiavelent of a new "type fixedTangential" with tangential velocity fixed and normal velocity free. (It might even make things easier knowing that my patch is vertical such that normal direction is along xhat, and tangential direction is along yhat.)

Any suggestions?

JulioPieri · January 14, 2022, 13:49

try coding your BC, or using swak4Foam.

have a look on how "fixedNormalSlip" works and implement a codedBC that adds a similar chunk of code, change the directions of interest.

January 12, 2022, 15:37	How to set a tangential-only velocity boundary condition	#1
bobuhito New Member BH Join Date: Dec 2021 Posts: 9 Rep Power: 4	I'm running a 2D transient flow simulation and have a flat patch at which I would like to force a pressure of 0 and tangential velocity of 0 (leaving normal velocity free, and gradients free, for the solver to calculate at each time step). If the flow were into the block, I know "type pressureInletOutletVelocity" works perfectly for this, but in the outflow case, for better convergence, this type does not constrain the tangential velocity. I don't think my case will have a convergence problem and would prefer to just keep the tangential constraint for both directions. At the most basic level, I just want the reversed constraint of "type fixedNormalSlip" which has normal velocity fixed but tangential velocity free. So, I am looking for the equiavelent of a new "type fixedTangential" with tangential velocity fixed and normal velocity free. (It might even make things easier knowing that my patch is vertical such that normal direction is along xhat, and tangential direction is along yhat.) Any suggestions? lourencosm likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to set Open boundary condition in FLUENT?	vincenzolights	FLUENT	5	March 30, 2020 10:40
Difficulty in calculating angular velocity of Savonius turbine simulation	alfaruk	CFX	14	March 17, 2017 06:08
Problem with assigned inlet velocity profile as a boundary condition	Ozgur_	FLUENT	5	August 25, 2015 04:58
Low Mixing time Problem	Mavier	CFX	5	April 29, 2013 00:00
help with velocity boundary condition potentialFoam	hfc	OpenFOAM Running, Solving & CFD	2	May 31, 2012 19:52

January 14, 2022, 13:49		#2
JulioPieri Member Julio Pieri Join Date: Sep 2017 Posts: 96 Rep Power: 8	try coding your BC, or using swak4Foam. have a look on how "fixedNormalSlip" works and implement a codedBC that adds a similar chunk of code, change the directions of interest.