[tRock]

Hello to all,


I am performing a chtMultiRegionFoam simulation where the fluid domain is inside the solid domain.



After generating the mesh I assigned the inlet and outlet with topoSet Maintain patchs in interior mesh for SHM in multiRegion


My inlet, outlet and walls are of type mappedWall. This will be used to couple the temperature between the fluid and solid domain through the boundary compressible::turbulentTemperatureCoupledBaffleMix ed or equivalent.



My question is.. Will this type of boundary have any influence on the fluid flow variables that are not being coupled [p, U, etc.] ? Will they work as standard "patch" type?


Best regards