|
[Sponsors] |
Error when executing simpleFoam - FOAM FATAL ERROR:(openfoam-2206) cannot find file |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 15, 2022, 12:18 |
Error when executing simpleFoam - FOAM FATAL ERROR:(openfoam-2206) cannot find file
|
#1 |
New Member
astri anindya
Join Date: Nov 2022
Posts: 3
Rep Power: 3 |
Hi all,
I am running a case of natural ventilation of a simple building (box) with open windows. I created it as an outdoor case inside the wind tunnel, write the case in Butterfly then trying to run it in openFoam. Everything is fine when I execute blockMesh and snappyHexMesh. However, when I execute simpleFoam I've got an error message: --> FOAM FATAL ERROR: (openfoam-2206) cannot find file "/mnt/c/Users/astri/butterfly/boxexplode_45/2/p" From virtual Foam::autoPtr<Foam::ISstream> Foam::fileOperations::uncollatedFileOperation::rea dStream(Foam::regIOobject&, const Foam::fileName&, const Foam::word&, bool) const in file global/fileOperations/uncollatedFileOperation/uncollatedFileOperation.C at line 540. FOAM exiting I am trying different setting, but It always goes the same way. Would anyone share a thought why this is happen? Any advice would be very much appreciated Best regards, Astri |
|
Tags |
error |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 09:07 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
Problem compiling a custom Lagrangian library | brbbhatti | OpenFOAM Programming & Development | 2 | July 7, 2014 11:32 |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |