|
[Sponsors] |
October 21, 2009, 05:57 |
dynamicRefineFvMesh on polyhedral meshes
|
#1 |
Senior Member
Frank Bos
Join Date: Mar 2009
Location: The Netherlands
Posts: 340
Rep Power: 18 |
Hi everyone!
It's been a while since my last forum post, I was extremely busy wrapping up my PhD thesis. If time allows me, I will increase my message board involvement! Now the problem. I am interested in using automatic refinement on arbitrary polyhedral meshes, which can be generated using ansys, snappy and some other tools. However, when running interDymFoam on the damBreak utility the following error occurs: ============ Selected 1178 cells for refinement out of 7854. hexRef8 : Dumping cell as obj to "/media/data/OpenFOAM/frank-1.6/run/tutorials/multiphase/interDyMFoam/ras/damBreakWithObstacle/cell_9.obj" cell 9 of level 0 does not seem to have 8 points of equal or lower level cellPoints:6(28 29 30 31 32 33) pointLevels:6{0} ============ Has anyone used dynamicRefineFvMesh before? Did anyone encounter and solve this problem? Best regards, Frank Bos
__________________
Frank Bos |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |
Polyhedral in parallel | drdr18 | FLUENT | 5 | April 3, 2009 17:56 |
[Commercial meshers] Importing Fluent polyhedral meshes | fra76 | OpenFOAM Meshing & Mesh Conversion | 2 | October 11, 2008 04:44 |
how to make polyhedral cell meshes | mmacrb | FLUENT | 3 | February 2, 2007 14:19 |
Polyhedral meshes in STAR-design | Lee | Siemens | 3 | March 10, 2005 16:43 |