|
[Sponsors] |
March 20, 2011, 01:05 |
interFoam problem
|
#1 |
New Member
|
Dear all,
I'd like to simulate a nozzle jetting, I have tried the tutorial of dambreak. I use the dambreak as template to do the simulation, but it failed. The following is the two models: one is with nozzle, the other is without nozzle. and there's no input flow or pressure on the inlet boundary. the problems are 1) the two models are the same, except the geometry. why the model w/o nozzle is successful when simulating, but the other one failed. 2) what means can improve it? Thanks. Best regards, Martin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
interFoam (OF 1.7.1) in parallel ..need help | farhagim | OpenFOAM | 4 | July 26, 2012 16:42 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |