|
[Sponsors] |
June 17, 2011, 22:18 |
-Pitzdaily XiFoam blowup !!!
|
#1 |
Member
|
Hi, I did the pitzDaily case with XiFoam, I made several test, but I have this problem: when I put two ignition point or increment the inlet velocity say from 15 m/s to 50m/s XiFoam blowup and show an error related with Janafthermo (saying that janaf is out of the limits) , someone has an idea about what could be the problem?
Thanks for your help best regards Felipe
__________________
Felipe G |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Several ignition sites with XiFoam? | lfgmarc | OpenFOAM Running, Solving & CFD | 4 | May 2, 2018 02:09 |
b eqn in XiFOAM | Farshad_Noravesh | OpenFOAM | 6 | May 28, 2011 13:36 |
[Gmsh] trouble with les model in XiFoam after convertion gmshTofoam? | lfgmarc | OpenFOAM Meshing & Mesh Conversion | 0 | May 24, 2011 23:35 |
Turbulent combustion error... XiFoam model | achinta | OpenFOAM | 1 | July 7, 2010 08:24 |
Run pitzdaily with xifoam | tavasoly | OpenFOAM Running, Solving & CFD | 0 | July 8, 2008 04:25 |