defining periodic boundary conditions to use in OpenFoam

Mahdi_Kh · May 7, 2022, 17:49

Hi everyone,

I was not sure where to put this question, but I hope to get some guidance from you.

I am converting a mesh from Fluent format to OpenFOAM. The mesh was originally created in ICEMCFD. For Fluent, we can define an "interface" boundary in the ICEMCFD for the boundaries we wish to use as periodic, and then change them to periodic inside the Fluent. I am not sure this step will be valid if at the end, I convert the mesh to OpenFOAM mesh, because the "interface" boundary is not recognized in the OpenFOAM I guess.

Have you had the experience of creating a mesh with periodic BC in ICEM and converting it to OpenFOAM?

I appreciate any comment and lead.

Thank you.

Mahdi_Kh · May 8, 2022, 12:07

I think I just needed to add "neighbourPatch". It is fixed now.

Thank you all.

KasperWayne · September 1, 2023, 06:20

Hello.

Do you remember where you added the `neighbourPatch`? Did you add it directly in the .msh file or did you change the boundary conditions in the `boundary` file?

May 7, 2022, 17:49	defining periodic boundary conditions to use in OpenFoam	#1
Mahdi_Kh New Member Mahdi Join Date: May 2016 Posts: 22 Rep Power: 9	Hi everyone, I was not sure where to put this question, but I hope to get some guidance from you. I am converting a mesh from Fluent format to OpenFOAM. The mesh was originally created in ICEMCFD. For Fluent, we can define an "interface" boundary in the ICEMCFD for the boundaries we wish to use as periodic, and then change them to periodic inside the Fluent. I am not sure this step will be valid if at the end, I convert the mesh to OpenFOAM mesh, because the "interface" boundary is not recognized in the OpenFOAM I guess. Have you had the experience of creating a mesh with periodic BC in ICEM and converting it to OpenFOAM? I appreciate any comment and lead. Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Centrifugal fan	j0hnny	CFX	13	October 1, 2019 13:55
Radiation in semi-transparent media with surface-to-surface model?	mpeppels	CFX	11	August 22, 2019 07:30
Multiphase flow - incorrect velocity on inlet	Mike_Tom	CFX	6	September 29, 2016 01:27
Problem with SIMPLEC-like finite volume channel flow boundary conditions	ghobold	Main CFD Forum	3	June 15, 2015 11:14
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 06:28

May 8, 2022, 12:07		#2
Mahdi_Kh New Member Mahdi Join Date: May 2016 Posts: 22 Rep Power: 9	I think I just needed to add "neighbourPatch". It is fixed now. Thank you all.

September 1, 2023, 06:20		#3
KasperWayne New Member Kasper Join Date: Sep 2017 Posts: 9 Rep Power: 8	Hello. Do you remember where you added the `neighbourPatch`? Did you add it directly in the .msh file or did you change the boundary conditions in the `boundary` file?